Burke Porter Machinery to manufacture Dynamometer for OEM in Korea

5/4/04 – Burke Porter Machinery has been awarded a contract to manufacture a two wheel drive dynamometer for a major OEM in Korea. The chassis dyno purchased provides an alternative to testing vehicles on the test track or highway. It will be installed below floor level, allowing vehicles to be driven onto the rollers and then held in place by a vehicle restraint system. The dyno will simulate road conditions in the speed, torque or road load control modes, allowing the vehicle to experience the same forces it would on the test track or highway.

Burke Porter Machinery awarded contracts to produce Four (4) Non-Contact Alignment machines

4/07/04 - Burke Porter Machinery has been selected to manufacture two (2) Non-Contact Alignment machines with robotic Auto-Toe Set for a major OEM J.V. in California and another two (2) Non-Contact Alignment machines for an OEM J.V. in Michigan.

Designed to perform production line measuring and verification of vehicle alignment parameters using a laser-based computerized measurement system, BEP state of the art NCA’s accurately and repeatably measure the vehicle’s toe, camber and caster settings.